1 screening scale conveyor installation:
1) rotating the adjusting nut, the driven shaft and the driving shaft distance to a minimum;
2) check the belt running direction, press (Figure 1) thick arrow direction will belt is sheathed in the tray.
3) the pallet adjusting on both sides of the adjusting nut, so that the belt tightness moderate. And the center position of the belt on the tray.
2 screening scale conveyor belt adjustment:
1) the belt tension adjustment to moderate, to run, to observe the skin condition;
2) if the belt in the tray, belongs to the normal state, without any adjustment;
3) if the belt to the left, can be adjusted as follows:
"Tightening" left belt, need adjustment. Adjust the side observation, until the belt back to the centre shall prevail. If the adjusting nut is very tight, do not force adjustment.
"Loosening" on the right side of the belt, need adjustment. Adjust the side observation, until the belt back to the centre shall prevail.
If still have relatively large, slowly adjusting to come back, can quickly adjust loose on the right side of the belt.
If the belt has been with the side baffle friction should immediately stop check.
